90) Preliminary project report for a road project must contain

the detailed estimated cost based on detailed design

the several alternatives of the project that have been considered

the soil survey, traffic survey, concept design and approximate cost

the contract documents for inviting tenders

Answer is:

the soil survey, traffic survey, concept design and approximate cost

Structural Engineering II MCQ with Answers

For more MCQ's Click Here

91) The heaviest I-section for same depth is

ISMB

ISLB

ISHB

ISWB

Answer is:

ISHB

92) Bending compressive and tensile stresses respectively are calculated based on

net area and gross area

gross area and net area

net area in both cases

gross area in both cases

Answer is:

gross area and net area

93) If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as

120 mm

160 mm

200 mm

300 mm

Answer is:

160 mm

94) In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate

fully by direct bearing

fully through fastenings

50% by direct bearing and 50% through fastenings

75% by direct bearing and 25% through fastenings

Answer is:

50% by direct bearing and 50% through fastenings

Structural Engineering II MCQ with Answers

For more MCQ's Click Here

90) Preliminary project report for a road project must contain

the soil survey, traffic survey, concept design and approximate cost

Structural Engineering II MCQ with Answers

Related Structural Engineering II MCQ with Answers

91) The heaviest I-section for same depth is

ISHB

92) Bending compressive and tensile stresses respectively are calculated based on

gross area and net area

93) If the thickness of thinnest outside plate is 10 mm, then the maximum pitch of rivets in tension will be taken as

160 mm

94) In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate

50% by direct bearing and 50% through fastenings

Structural Engineering II MCQ with Answers